#Ia gns3 for mac manual
#Ia gns3 for mac software

To get command syntax help, please enter '?' as an argument of the command.įound that only 127.0.0.1 did not meet the expected 10.67.8.100, reconfigure immediatelyġ0.67.8.100 is local ip, 10.67.8.52 is gateway Use the command show ip to view the IP configuration of PC1, neither ipconfig nor ifconfig Router (config ) #interface fastEthernet 1/0 Pass down the command to configure the routing FastEthernet1/0 interface Router >enable Of course, if you don't have a route, it must be problematic Instead of deleting PA-GE on R1, I could ping it. Gateway of last resort is 10.67.255.254 to network 0.0.0.0Ĭ 10.67.0.0 is directly connected, FastEthernet1/0Īs described in the accompanying description, C indicates the connected state, and the FastEthernet1/0 interface state is normal.Here's one thing: I used GigabitEthernet1/0 before, and I couldn't live or die. O - ODR, P - periodic downloaded static route Ia - IS-IS inter area, * - candidate default, U - per-user static route I - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2Į1 - OSPF external type 1, E2 - OSPF external type 2

#Ia gns3 for mac manual

GigabitEthernet0/3 unassigned YES NVRAM administratively down downįastEthernet1/0 10.67.8.52 YES manual up upįastEthernet2/0 unassigned YES unset administratively down downįastEthernet3/0 unassigned YES unset administratively down downįastEthernet4/0 unassigned YES unset administratively down downĮxecute the command show ip route to view the router's routing settings Router >enableĬodes: C - connected, S - static, R - RIP, M - mobile, B - BGPĭ - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area GigabitEthernet0/2 unassigned YES NVRAM administratively down down GigabitEthernet0/1 unassigned YES NVRAM administratively down down Interface IP-Address OK? Method Status ProtocolįastEthernet0/0 10.10.10.10 YES NVRAM down down Normally, there will be no problem if the VM is not on my computer.Ĭheck that the analog devices used in the experiment are all on.Ĭheck if the FastEthernet1/0 network card is on, up is OK Whether the VM can be connected properly or not, because my environment is running on gns3 vm, so I need to pay attention to it.

#Ia gns3 for mac software

Is the GNS3 software itself functioning properly

Similarly, router R1 ping s the e0 port of host PC1 Ideas for sorting out 0x03 1. Host PC1 ping does not pass through f1 port of router R1